What is BS EN 62788-1-2-Photovoltaic encapsulants and polymeric materials about?
The EN 62788 series is a European standard that discusses materials used in photovoltaic modules. The main objective of EN 62788 is to provide the measurement procedures for materials used in photovoltaic modules.
BS EN 62788-1-2 is a part of a series of documents that provides a method and guidelines for measuring the volume resistivity of materials used as encapsulation, edge seals, front sheets, back sheets, or any other insulating material in a photovoltaic (PV) module. The test is performed on dry, humid, or wet preconditioned samples. In the case of front sheets and back sheets comprised of multiple layers, the measured resistivity is an effective value. This test is designed for room temperature measurement but can also be utilized at higher temperatures.
Degradation of PV modules is known to occur in part by electrochemical corrosion, and other potential induced degradation processes. These processes may be dependent upon the resistivity of a polymeric component. Therefore, the DC resistivity of polymeric components is relevant to module design and durability in the field. The resistivity may depend on cure state, temperature, water content, and voltage history. A number of options are included to allow the measurement to be performed in a manner consistent with representative fielded module conditions.
Who is BS EN 62788-1-2-Photovoltaic encapsulants and polymeric materials for?
BS EN 62788-1-2 on measurement procedures for materials used in photovoltaic modules useful to:
- PV module manufacturers
- PV power system manufacturers
- Photoelectric device manufacturers
- Solar energy engineering industry
-
Product designers
- Quality assurance and testing personnel
Why should you use BS EN 62788-1-2-Photovoltaic encapsulants and polymeric materials?
Datasheet reporting of plastics and polymers used in photovoltaic modules is required to ensure that materials and products perform as expected and last as long as possible.
BS EN 62788-1-2 provide you with standard methods and guidelines for measuring the volume resistivity of materials used as encapsulation, edge seals, front-sheets, back sheets, or any other insulating material in a photovoltaic (PV) module.
Guidance in BS EN 62788-1-2 can help you in quality control of electrically insulating material as well as for reporting in product datasheets. You can apply methods in BS EN 62788-1-2 for the purpose of material acceptance, material selection, process development, design analysis, or failure analysis.