Electrically propelled road vehicles. Functional and safety requirements for power transfer between vehicle and external electric circuit. - Part 5: Automatic conductive power transfer

Electrically propelled road vehicles. Functional and safety requirements for power transfer between vehicle and external electric circuit. - Part 5: Automatic conductive power transfer

£168.00
£168.00
£151.20
Sold out

1   Scope

This document defines requirements for the onboard system (vehicle side) related to the automatic connection for conductive alternating current (AC) and/or direct current (DC) power transfer between electrically propelled road vehicles (EVs) and external electric circuits. This document addresses the following aspects:
  1. — electrical and mechanical safety requirements;
  2. — compatibility requirements;
  3. — environmental conditions;
  4. — functionality requirements;
  5. — test procedures.
This document applies to:
  1. — EVs supporting automatic connection of a vehicle inlet according to IEC 62196-2, IEC 62196-3, IEC TS 62196-3-1 or IEC TS 633791 (category 1) and
  2. — EVs supporting automatic connection of a category 3 vehicle inlet or category 3 plug (typically at the underbody of the vehicle) according to IEC TS 61851-26.

NOTE 1 IEC TS 61851-26 does not include automatic connection of vehicle inlets or plugs of category 1 and category 2, that can also be mounted at the underbody of the vehicle.

Requirements for EVs equipped with an ACD or ACD counterpart of category 2 are specified in EN 50696 and IEC 634072.
Requirements for simultaneous operation of multiple power transfer interfaces are under consideration and not covered in this document.

NOTE 2 Requirements for ACD infrastructure, communication sequence and communication interface are specified in IEC 61851-23-1, IEC TS 61851-26 and IEC TS 61851-27.

NOTE 3 EMC requirements for vehicles conductively connected to the supply network are defined in IEC 61851-21-1.