What is BS EN 50194-2 - Performance requirements for electrical apparatus about?
BS EN 50194-2 is a European standard that discusses gas detection and the electrical apparatus required for the same. BS EN 50194-2 is the second part in the multi-series that specifies test methods and performance requirements for electrical apparatus for the detection of combustible gases designed for continuous operation in a fixed installation in recreational vehicles and similar premises.
BS EN 50194-2 specifies apparatus designed to operate in the event of an escape of liquefied petroleum gas (LPG) and/or petrol (gasoline) vapour and to provide a visual and audible alarm and an executive action in the form of an output signal that can actuate directly or indirectly a shut-off device and/or other ancillary device. The main objective of BS EN 50194-2 is to set up efficient and reliable alarm warning systems.
NOTE 1: For caravan holiday homes EN 50194-1 applies.
NOTE 2: Apparatus complying with this BS EN 50194-2 is not considered suitable for industrial or commercial installations for which EN 60079-29-1 applies.
NOTE 3: Apparatus tested in accordance with EN 60079-29-1 will not necessarily comply with this BS EN 50194-2.
Who is BS EN 50194-2 - Performance requirements for electrical apparatus for?
BS EN 50194-2 on electrical apparatus gas detection is relevant to:
- Manufacturers of electrical apparatus used for gas detection
- Manufacturers and suppliers of gas detection alarm and warning devices
- Manufacturers of safety and hazard protection equipment
- Product designers
- Fire safety department
Why should you use BS EN 50194-2 - Performance requirements for electrical apparatus?
The performance and characteristics of electrical apparatus and sensors are crucial to the functioning of alarm and warning systems.
BS EN 50194-2 walks you through the construction, as well as tests and performance requirements that enable you to demonstrate the reliability of your products.
If you are a manufacturer of gas detection alarms and warning devices, compliance with BS EN 50194-2 can ensure the electrical apparatus meets the required level of operational efficiency in the event of a hazard. You can prevent failure of fault signals and sensors, while minimising incidence of built-in delay of the output signal, thus strengthening safety protocols in the aforementioned premises.