What is BS EN 50441-2 - Cables for indoor residential telecommunication installations about?
BS EN 50441 is a series on cables for indoor residential telecommunication installations. Cables are an assembly of one or more wires running side by side or bundled, which are used to carry electric current. BS EN 50441-2 specifies the constructional details and performance requirements for cables for indoor Residential Cabling Systems characterized up to 100 MHz. Cables in BS EN 50441-2 are based on the common design rules specified in EN 50290-2-1 and are specifically intended for supporting ICT and BCT applications (telephone, computer, and TV services) as specified in EN 50173-4.
The cables covered in BS EN 50441-2 are intended to operate with voltages and currents normally encountered in communication systems. The maximum current rating per conductor is 3 A/mm² unless otherwise specified in BS EN 50441-2.
Note 1: These cables are not intended to be used in conjunction with low impedance sources, for example, the electrical power supply of public utility mains.
Note 2: Cables covered in BS EN 50441-2 may however be subjected to voltages of not more than 300 V a.c. or 450 V d.c and comply with the requirements of the Low Voltage Directive.
Who is BS EN 50441-2 - Cables for indoor residential telecommunication installations for?
BS EN 50441-2 on cables for indoor residential telecommunication installations is useful for:
- Telecommunication component manufacturers
- Telecommunication equipment manufacturers
- Design engineers
- Quality control personnel
Why should you use BS EN 50441-2 - Cables for indoor residential telecommunication installations?
Electrical cables are used to connect two or more devices, enabling the transfer of electrical signals or power from one device to the other. BS EN 50441-2 introduces the cables that are installed in ducts, in raceways, directly buried in plaster, and surface mounted by glueing or stapling. Additional tests are undertaken were and agreed upon between customer and manufacturer to establish the compatibility between the cable sheath and the glue or the plaster, or to establish the stapling ability.
The values given in BS EN 50441-2 are for information only. The given formulas specified are used to determine compliance with figures rounded to one decimal place. The transmission measurements should be performed on cable samples of 100 m laid out without stress. Other sample configurations that satisfy the performance recommendations of BS EN 50441-2 will be deemed to be acceptable provided correlation to the reference method has been verified. In case of conflict, the first method (100 m, off-reel) should be used. Using BS EN 50441-2 you can specify the constructional details and performance requirements for cables for indoor Residential Cabling Systems characterized up to 100 MHz.